Learning A Transmitter - Key Automation 900CT20224 Instrucciones Y Advertencias Para Su Instalación Y Uso

7. On reaching the point where motor M2 closing deceleration is required, press SBS. M2 motor
movement continues at low speed (the display shows SC.L.)
8. On reaching the mechanical end stop of motor M2, motor M1 starts closing
9. On reaching the point where motor M1 closing deceleration is required, press SBS. M1 motor
movement continues at low speed (the display shows SCL)
10. When motor M1 reaches the closed position, motor M1 stops and restarts in opening
11. On reaching the point where motor M1 opening deceleration is required, press SBS. M1 motor
movement continues at low speed (the display shows SOP)
12. When motor M1 reaches the open position, motor M1 stops and motor M2 starts in opening
13. On reaching the point where motor M2 opening deceleration is required, press SBS. M2 motor
movement continues at low speed. (the display shows SO.P.)
14. When motor M2 reaches the open position, motor M2 stops
15. M1 and M2 resume closing according to the offset parameter entered in the menu, i.e. the gate
closes automatically according to the set travel
16. Run a number of opening, closing and stop manoeuvres, to check that the system is stable and there
are no assembly defects.
The deceleration points not assigned manually will be automatically set at 20% of the control unit stroke

4.4 - Learning a transmitter

A transmitter can be "learned" via the specific programming menu or by remote memorisation, using a previously memorised transmitter.
MEMORISING A REMOTE CONTROL
If you are in programming mode exit pressing the MENU button until -- appears. Press the DOWN
(RADIO) button for more than 2 seconds. Until the display shows the word "rad" (radio), then release
the button
1. Press and release the DOWN (RADIO) button a number of times equal to the number of the output
to be activated: once for output STEP BY STEP, twice for output PARCIAL, three times for output ONLY
OPEN, four times for output LIGHT ON/OFF, five times for output PRESET (button 1 = output 1, button
2 = output 2, button 3 = output 3, button 4 = output 4)
2. The KEY LED will flash a number of times equal to the number of the output selected, with 1 second
pauses between flashes
3. Press the button of the remote control to be memorised within 7 seconds, holding it down for at least
2 seconds
4. If the memorisation has been successful, the KEY LED will give one long flash
5. To memorise another remote control on the same output, repeat point 3
N.B If no commands are given for 7 seconds, the receiver automatically quits the programming mode
EN
M1 7
M2
SBS
M1 8
M2
9
M1 M2
SBS
10
M1 M2
11
M1 M2
SBS
M1 12
M2
M1
13
M2
SBS
M1 M2 14
M1 M2 15
+ +
+ 1s + 1s
2 s
>3s
27