weasy KFX32 Manual De Instrucciones página 7

Preparation for first use / cold machine state
1. pour water into the water tank, and the water level should not exceed the "Max" mark in the
water tank.
2. plug in the power supply, and then press the 'on/off button', the upper indicator light turns
blue flicker at this time.Then you press the 'manual control button' and the water pump will start
to work,it will pump the water from water tank into the machine for heating.
3. The machine starts to warm up. At this time, the coffee switch indicator lights will fliker. To
wait untill the light turns to continuous illuminates from fliker,the pre-heat is finished, it will take
about 2 minutes.
4. Then press "one cup button",the machine will flow hot waters out,you can use the water to
wash the filter or cups.
start to make coffee
1. Place the filter into the funnel.
2. When the machine is preheating, you can fill the coffee powder into the filter and then flat and
tight the powder by the tail of spoon at the mean time. (the coffee powder can not be too coarse
or too thin)You can also clean the edge of filter with a brush or your hand
3. Insert and lock the funnel as indicated,then place the coffee cup under the funne
4. Press the 'one cup button',the machine begins to flow out one cup of coffee (or press '2 cups
button', ,the machine begins to flow out two cups of coffee . or press 'manual control
button',then the machine begins to flow out the coffee,when it reach to the capacity which you
want,press the 'manual control button' again,the machine will stop flowing out the coffee.)