Worx WG255E Traducción De Las Instrucciones Originales página 12

5. TO REMOVE OR INSTALL BATTERy
PACK (See Fig. F)
Depress the Battery Pack Release Latch (7) to
release battery pack from your Hedge trimmer.
After recharging, insert the battery pack into
trimmer's battery port. A simple push and
slight pressure will be sufficient. Check to see
if the battery is fully secured.
6. STARTING AND STOPPING
BEFORE STARTING yOUR HEDGE
TRIMMER
Remove Blade Sheath (9).
TO START yOUR HEDGE TRIMMER
Your hedge trimmer is equipped with two
Switch Levers (5 & 6). Both Switch Levers
need to be pressed for the hedge trimmer to
start. Depress and hold the Front Switch Lever
(5) and press the Rear Switch Lever (6) (See
Fig. G)
TO STOP yOUR HEDGE TRIMMER
Move hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See
Fig. H).
12
wARNING: If any parts are missing,
damaged or broken, do not operate
your hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury. DO NOT USE wITHOUT
HANDLE AND GUARD.
7. HOw TO USE yOUR HEDGE TRIMMER
Note that the front switch lever can be
activated on three sides, giving you many
choices for a comfortable grip. Before cutting
an area, inspect it first and remove any
foreign objects that could become thrown
or entangled in the blades. Always hold the
trimmer with both hands and with the blade
away from you before turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade. (See Fig. I& J)
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
Cordless Hedge Trimmer
trimmer. Release the two Switch Levels (5 &
6) before attempting to clear jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. I). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
SIDE CUTTING
When trimming the sides of the hedge,
begin at the bottom and cut upwards (See
Fig. J), tapering the hedge inward at the top.
This shape will expose more of the hedge,
resulting in a more uniformed growth.
8. CLEANING
REMOVE THE BATTERY PACK. Use a soft
brush to remove debris from all air intakes
and cutting blade.
Wipe the surface with a dry cloth.
wARNING:
Never use water for cleaning your
trimmer. Do not clean with chemicals,
including petrol, or solvents as this may
damage your trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure the battery is
removed from the trimmer. Apply oil blades
periodically (See Fig. K).
AT THE END OF THE CUTTING SEASON
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
EN