Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

1
Insert (2) plastic screw retainers into
square holes in hood.
3
Install (4) screws with washers to
secure deflector to hood.
5
NOTE: DO NOT OVER TIGHTEN
Apply bump ons to surface of hood
7
NOTE: Actual application may vary slightly from illustrations.
Open Hood.
2
Set the wind deflector in place with the tabs sliding
between the hood and rubber seal and align with holes.
hood shield
seal
washer
screw
4
6
7
Page 2 of 3
Remove (2) rubber seal
retaining fasteners.
Close Hood.