Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CLEANING FILTERS
This vacuum cleaner is equipped with a sponge filter and 1 HEPA filter, capable of retaining particles and
small organisms such as mites and pollens. In this way the air re-emitted from the cleaner will be more
healthy and clean. To maintain the performance of the vacuum cleaner is recommended to clean the filters
regularly.
- Rotate the cover of the dust bin (10), aligning the arrow▼ on the lid with OPEN●.
- Remove the HEPA filter and the foam filter.
- Rinse the HEPA and the sponge filter with a soft brush and/or with warm water and DRY THEM
THOROUGHLY.
CAUTION: Do not use detergent to clean the filter or the cover. The HEPA filter must be completely
dry before using the vacuum cleaner.
PROBLEMS AND SOLUTIONS
PROBLEM
The cleaner does not
work
Suction power is
weak
Dirt comes out of the
container
Unit cannot vacuum
MAINTENANCE AND CLEANING
CAUTION: before starting any cleaning/maintenance operations, unplug the unit from the electrical
outlet.
Normally this vacuum cleaner is not noisy. But when the dust container is full or the HEPA filter is clogged,
the noise emitted changes, so the suction power. In addition, thanks to the transparent container, you can see
the amount of dirt making it very easy to understand when you need to empty the container. Even the filters
should be cleaned periodically. These filters can also be damaged or exhausted (HEPA filter) and should be
replaced with new filters. Emptying the dust container and cleaning the filters as stated in this booklet, you
will avoid stressing the motor.
Clean the main body with a damp non-abrasive cloth, avoiding the use of aggressive detergents or abrasive
cleaners, which could ruin the aesthetic parts of the device.
The cloth should not be too wet, since the water penetrating the device, can seriously damage it. Cleaning
filters by following the specific instructions on this guide.
TECHNICAL FEATURES
•
Power supply: AC 220-240V
•
Dust capacity 0,5 lt
•
Vacuum 15 kPa
•
Accessories: telescopic tube, floor brush, multi-crevice nozzle, pet brush and multifunction compact
brush
CAUSE
The unit is not correctly connected
Electricity is down.
The container is full.
The unit is obstructed..
Filters need to be cleaned.
Container is full.
Not correctly installed.
Broken container.
Blocked hose.
Dust container is full.
~
50/60Hz, 450W
SOLUTION
Plug the unit.
Check the distribution board.
Empty the container.
Unplug and check if something obstructs the unit
Clean or change the filter.
Empty the container and installi t again.
Replace the container.
Remove objects inside the hose.
Empty the container and clean the filters
15
Tabla de contenido
