McElroy DATALOGGER 7 Guia De Inicio Rapido página 4

General Safety
DataLogger equipment is not
®
explosion proof . Operation
¡PELIGRO! ¡PELIGRO!
of equipment in an explosive atmosphere may
result in serious injury or death .
Do not operate this equipment in an explosive
atmosphere .
DataLogger App
®
Connect Pressure Transducer to
Fusion Machine
1 . Connect the pressure transducer end of
the cable to the DataLogger port of fusion
machine . Refer to the operator's manual of
the fusion machine for the port location .
2 . Connect the connector end of the cable to
the connector port on the back of the tablet .
Starting the DataLogger 7 App
®
1 . Open to the Home screen .
2 . Tap the DataLogger 7 App icon to open
®
the application .
Select Software Language
1 . Tap Settings on the Main Menu .
2 . Tap Preferences on the Settings Menu .
3 . Tap the Language button and set to the
desired language .
3
Entering Vault Information
1 . Tap the lock icon on the main screen to
open the DataLogger Vault log in screen .
® ™
2 . Log into a DataLogger ® Vault ™ account
using a username and password .
If you do not have a Vault account, open
an internet browser on this tablet and go to
vault .mcelroy .com . Create an account and
return to the DataLogger 7 App and enter
the username and password .
Log a Fusion Joint
1 . Tap the START button .
2 . Follow the on-screen instructions to enter all
the joint information and select the fusion
parameters .
After the setup is completed, logging of the
fusion joint can begin .
Troubleshooting
Perform a Hard Reset
1 . If the tablet is frozen and won't respond,
hold the power key down for 2 to
3 seconds to see if the menu with the
"Power off" option appears, then select that
operation .
If the menu doesn't appear, hold the power
key down for 10 seconds . This causes a
hardware shut off . Press the power key
again to power it on .
If hold the power key for 10 seconds
doesn't shut off the device, hold the power
button down for 20 seconds . Batteries are
forced to electrically disconnect from the
tablet, causing a complete shut down . The
tablet cannot be powered on again until an
external power supply is attached .
IMPORTANT: To be able to power the
device on again, you will need to be able
to use the external power supply . You will
need to have access to a power source for
the power supply .
NOTICE: Forcing a shut-down while the
unit is running can cause damage to the
device . NEVER force shut-down the tablet
under normal operating conditions .
4