Kohler GLASSWORKS K-9719 Manual Del Usuario página 8

Start the #12 x 1-1/4" self-tapping screw, through the
corner mounting plate and into the bottom cover plate.
Check alignment so cover will seal against side glass
panels.
Apply small bead (about 1/8" Dia.(3mm)) of RTV sealant
1/4" (6mm) behind and parallel to front edge of bottom
cover plate.
Insert two pins at rear of bottom cover plate into receiving
slots of corner bracket.
Support cover with hand while tightening screw mount. Do
not overtighten screw.
7. INSTALL CENTER GLASS
Remove protective backing from tape for center glass
panel.
Align and lower glass into mounting area as per side glass
panel instructions.
Glass should extend over bottom cover plate.
8. INSTALL CENTER GLASS
Insert trim into vinyl mount strip (center).
Apply trim strip with vinyl mounting strip to corresponding
protrusion as shown. Push trim pieces into vinyl mounting
strips.
AB
112896-2-
8
Corner Plate
Bottom Cover Plate
Aluminum Center
Trim Radial
Aluminum Side
Radial Member
Kohler Co., Kohler, WI U.S.A.