Kohler GLASSWORKS K-9719 Manual Del Usuario página 6

Apply foam gasket to shower door system by peeling off
backing and locating foam directly in front of shower
extrusion. Do not compress foam gasket yet.
Interlock shape of side radial into tabs in corner bracket.
Secure side radials walls with the screws provided.
Repeat on opposite side of unit.
After both side radials are installed and tightened, place
corner plate tabs into receptors on corner bracket and
tighten corner bracket mounting hardware (lag bolts or
bolts and screws).
Move nylon nuts forward to slightly compress foam
gaskets. Adjust gaskets if necessary.
4. INSTALL CENTER RADIALS
Match center radials to positions on headers by colored
markings on hanger end of radials and mounting position on
headers.
Remove first nut and washer from each center radial
assembly. Back off the remaining nut to allow decorative
cover to slide rearward.
Put stud through hole in corner bracket and drop front of
center radials down so hanger hooks on the shower door
upright extrusion.
NOTE: If wall jambs are installed at minimum condition, it
may be necessary to eliminate front hex nut on center ra-
dial.
Apply foam gaskets to both mating faces of center radials.
Apply gasket to end of radial.
Replace washer and nylon nut. Alternately tighten rear nuts
on left and right radials to snug. Do not overtighten.
Tighten forward nuts to slightly compress foam gaskets.
Readjust side radials if glass mounting surfaces are not
aligned in the same plane on top of header and side radial
extrusions.
AB
112896-2-
Header
Side Radial
Upright
Foam
Gasket
Foam Gasket
Side View
Tabs
Corner Plate
Corner Plate
Washer
Nut
Stud
Washer
Nut
Front
View
6
Wall
Foam Gasket
Front View
Corner
Bracket
Center
Foam
Radial
Gasket
Upright
Foam
Gasket
Kohler Co., Kohler, WI U.S.A.
Header
Foam
Gasket
Upright