Kohler GLASSWORKS K-9719 Manual Del Usuario página 4

INSTALL HEADERS
Header is supplied for an adjustment range per wall jamb
of 3/4" (2cm). End of header usually needs trimming.
Measure the X-dimension (#1 or #2), which is the
adjustment made to the shower door wall jamb for plumb
at top of wall jamb.
Subtract the X-dimension from the 3/4" (2cm) maximum
allowable adjustment to get the Y-dimension to be
trimmed from the header.
Trim end very carefully and squarely. Use miter box, fine
tooth hacksaw and file.
Repeat measurement process for opposite wall jamb and
header.
Trim opposite end of header per new measurements.
Check header for fit on shower unit, and make
adjustments as necessary.
From underside only of headers, remove facing from the
two parallel strips of double-faced tape. Do not remove
facing from the single strip of tape on the top of the header.
Press header around the perimeter of the system.
AB
112896-2-
VIEW
"A-A"
Wall
Jamb
X1
3/4" (2cm)-X1=Y1
VIEW
"A-A"
3/4" (2cm)-X2=Y2
Header
Header
Remove Facing
Here
4
VIEW
"A-A"
Header
3/4" (2cm)-X1=Y1
VIEW
"A-A"
Wall
Jamb
X2
3/4" (2cm) -X2=Y2
Do Not Remove Facing
Here At This Time
Kohler Co., Kohler, WI U.S.A.