Preparation For Welding - WELDY booster EX2 Instrucciones De Funcionamiento

Description of tool
3
2
1
1. Welding shoe
2. Hot air tube group
3. Tool rest
4. Welding rod openings
5. Hot air blower
Instruction for tool switch:
• To switch the tool on, press and hold the on/off switch (10).
• To switch the tool off, release the on/off switch (10).
• For automatic continuous operation when the on/off switch (10) is actuated, press the locking device of the
on/off switch (9).

Preparation for welding

Before switching on the power supply, all switches must be switched off and the controller must be set
to «0».
The handheld extruder must not be used in flammable surroundings or when there is a risk of explosi-
on. A stable working position must be ensured during operation. The power cable and the welding rod
must be unobstructed and must not hinder the user or third parties during operation.
Ensure power supply voltage is single phase 220V~230V,
with minimum power load capacity of 3000 W.
12
4
11
10
6. Tail handle
7. Drive unit
8. Overload protection fuse
9. Locking device drive on/off switch
10. Tool drive on/off switch
5
8
4
9
12
6
13
7
4
11. Handle
12. Air temperature potentiometer
13. Hot air blower switch
14. Filter
14
3