They will check that the cable part of the plug is adapted to the power used by the appliance. In
general, the use of adapters or extension leads is not advisable; if this is necessary, they must be in
accordance with the safety regulations and their amperage capacity must not be less than the
maximum for the appliance.
Before each usage, check that the appliance is in good condition and that the power cord is not
damaged: if in doubt, check with a professional, qualified technician.
The mains socket must be easily accessible in order to disconnect the appliance with ease in case of
emergency.
Position the appliance away from:
- sources of heat (e.g. open flames, gas ovens, etc.)
- deposits of liquids (e.g. sinks, etc.) to avoid falling into or splashing with water (minimum distance 2
metres).
- fabrics (curtains, etc.) or loose materials, which may obstruct the ventilation grille; in addition, check
that the front part is free of volatile materials (dust, etc.).
The supporting surface must be stable, flat and even (so that the appliance does not tip over).
ASSEMBLY
Warning: the fan may be used only if it is fully and properly assembled, that is to say, complete with
the base and the grille.
Warning: always disconnect the appliance from the mains supply before assembling. if in doubt, have
the operation checked or carried out by a qualified technician. For the assembly refer to Fig. 1.
ASSEMBLE OF BASE
Set the column in place on the base and secure it using the "L" screw with washer while also engaging
the counterweight.
Make sure column and base and counterweight are firmly coupled.
Loosen the Height Adjustment Collar on top of the Inner Tube.
Pull the Inner Tube out from the Outer Tube to adjust the tube to the desired height and tighten the
collar.
If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box down over
the Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly secured
ASSEMBLE OF BLADE AND GRILLE
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that
the locating pegs on the motor housing are engaged correctly in the holes of the rear grille.
Tighten the Rear Grille Mounting Nut clockwise. DO NOT OVERTIGHTEN IT.
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin that
passes through the motor shaft.
Tighten the blade cap by turning it anticlockwise.
Position the front grille against the rear grille so that the holes in the rims that accept the small nut and
bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten at the stage.
Push the grille retaining clips into position ensuring that they engage correctly on the rim of the grille.
Fully tighten the small nut and bolt that passes through the rim of the grille.
16