Intended Use; Identi Cation Plate; Assembly - Wolf Garten Lycos 40/400 M Manual De Instrucciones

EN

Intended use

This lawnmower is intended solely
- for mowing lawns in domestic and hobby gardens,
- for use in accordance with the descriptions and
safety information given in this operating manual.
Any other use is classed as an unintended use.
The user is liable for any damage arising from unin-
tended use.

Identi cation plate

Position
The identi cation plate is located at the lawnmower
casing.
Note
The identi cation is considered as a docu-
ment. It must ne er be altered or obliterated.
Structure
1 Guaranteed sound level
2 CE label
3 Manufacturer
4 Device group
5 Model name
6 Model number
7 Serial number
8 Power
9 Motor speed in rpm
10 Weight
11 Rated voltage, current type
12 Protection class / IP code
13 Disposal instruction
14 Year of manufacture
24

Assembly

Attaching the handle
(Fig.
Attention!
When folding the handle together or folding the
handle out, the cable may be damaged. Ensure
that the cable is not kinked or squeezed.
Grip in the handle recess of the de ector
ap and pull the de ector ap upwards until
the hook on the rear side of the casing and the
hook on the underside of the de ector ap engage
with a loud click
Then lower the de ector ap again
The grass is easily ejected through the resulting
gap between the de ector ap and the casing
when mowing without the grass collector. ou
can nd more information in the section "Mowing
without the grass collector .
Now x both handle mountings
part of the handle
Attach the bottom part of the handle to the handle
mountings so that it clicks in
handle up to the end of the handle mounting
Slightly pull the bottom part of the handle apart at
its ends and push onto the threaded screws lo-
cated on the left and right side of the casing
Then position the two washers
threaded screws
Push the threaded pins
levers , until the hole is visible
these tightly with nger and thumb and screw
in the quick-release levers together with the
threaded pins in a clockwise direction
there is a gap of approximately 10 mm
Secure the bottom part of the handle, by folding
the quick-release levers upwards towards the
lawnmower .
Attach the top part of the handle
tioning it on the bottom part of the handle
Hold the top part of the handle rmly with one
hand and with the other hand insert the screw
from outside into the holes at the left side of the
handle .
Position the washer
other side .
Intended use
)
.
.
to the bottom
, see .
. Push the
on the
.
into the quick-release
. Hold
, by posi-
on the screw from the
.
.
until
.
.