Texi Power 550 S Instrucciones De Uso página 6

EN
3. Power connection and grounding
Ground wire (green/yellow) must be grounded. Use the correct connector and extension wire when connecting ground wire to
Earth and secure it tightly. Connect as shown.
Yellow green line
Ensure all power cord, signal wire and grounding wire not be pressed by other matter or over-twisted, and not be too
close to belt and belt wheel (keep 3 cm distance for safety).
A 1Ф/220V power from a 3Ф/380V Power source Connection.
If the system have no Neutral point, then this servo motor is not suitable for this connection.
Neutral
Grounding
4. Definition of connectors on the control box
Motor power
1 Earth Grounding
2 Motor-A Phase A
3 Motor-B Phase B
4 Motor-C Phase C
Encoder
1 VCC +5v
2 ECNA+ Encoder A
3 ECNB+ Encoder B
4 UP+ Needle up signal
5 GND 5v Grounding
6 HALLC Hall-C
7 HALLA Hall-A
8 HALLB Hall-B
9 DN+ Needle down signal
4
Box
Controller
Lamp
1 VDD-L
2 GND
Synchronizer
1 GND
2 VGC
Input1
3
4 UP+
Pedal
1 Pedal
2 GND
3 +5v
Box cable
Green yellow - ground
Brown AC220 V
Green yellow - ground
Plug
Blue neutral
Controller
+
-
5v GND
+5v
Input 1
Needle down signal
Pedal signal
5v GND
+5v
Texi Power 550 S / 750 S
Brown AC220 V
Blue neutral
Controller