Funkwerk Active antenna Manual De Instrucciones página 25

6. Draw the protection cap carefully from the coaxial line.
Note! The protection cap is needed for the wall duct.
7. Connect the HF contact that is now exposed carefully with the middle
connector of the data stick mounting  The antenna is in operation when the
green LED of the data stick mounting  lights up.
Attention! This connection is not permanent! [only for testing]
8. Now insert the data stick into the mounting , clamp between the mounting
brackets respectively.
9. Check transmitter performance with the provider software. Change the
position of the antenna if necessary.
10. Establish and fix the position of the antenna.
11. Draw the HF contact off the coaxial line carefully from mounting 
subtract.
25