General Installation; Maintenance Instructions - Roca GENOVA Instrucciones De Montaje

GENERAL INSTALLATION

GB
The acrylic bath can be delivered in various configurations:
- Without feet, for setting into a bed of sand or in masonry.
- With the crosspieces of the feet detached.
It is essential in all cases that the weight of the bath is borne by its bottom and its edge
at the same time, and so the floor, and the side walls if present, must be able to bear that
weight with no sign of sagging.
Protect the bath until the work is finished. Covering the bath with the packing plastic and
cardboard is recommended, or else with a thick soft fabric.
If a blowtorch is used during installation, do not direct the flame towards the bath.
Possible scratches on bright baths may be removed with wet emery paper (nº 800), and
then buffed with a solventfree polish of the type used for car paintwork.

mAINTENANCE INSTRuCTIONS

Avoid all contact with lacquers, nail varnish remover, organic solvents, lighted cigarretes,
etc...
To prevent scale deposits: Always start off filling the bath with cold or lukewarm water. Dry
after use.
Hard
Cl
neutral
soft