Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Use and intended purpose
The Servo Drum Lifter enables users to easily lift, turn and move steel or plastic drums
Load capacity: 300 kg
4. Technical description
The drum lifter can be supplied with 4 different wheel bases:
Servo Model
FW 8-
Wheel base
narrow
Total height (mm)
1540
Lifting range (mm)
120 - 750
Version
with hydraulic pump
The Servo Drum Lifter includes the following features:
stable wheel base with lifting mast
-
pivot-mounted prism jaws with securing strap (explosion-proof version with electrically conductive
-
design)
hydraulic pump with lifting cylinder or crank with winch
Gear mechanism with hand wheel
-
two castors and two wheels (explosion-proof version with electrically conductive design)
-
5. Assembly
Drum lifter with hydraulic pump:
Before using for the first time, loosen the oil screw on the hydraulic cylinder and
raise the drum lifter with a load to remove the air from the hydraulic system. Then
re-fasten the oil screw tightly. You can also remove any air bubbles from the
hydraulic system this way if required at a later date.
If you replace the oil screw with a screw with a holed head (supplied with some
models), air is permanently removed from the hydraulic system
6. Specifications
See type label
7. Operation
Loading
1.
Raise the drum grippers as far as the top rim of the drum. Ringed steel drums can also be gripped
Align the drum lifter with the centre of the drum and move towards it.
2. Place the prism jaws around the middle of the drum between the rings.
3. Place the strap around the drum and fasten very tightly with the ratchet.
4. Ensure the drum is securely held.
5. Lift the drum using the hydraulic pump or the crank
Warning:
Never loosen the strap when drum is raised.
1.
Moving
Pull or push the drum lifter to its new destination using the push handle.
The drums may only be slightly raised when being transported.
Only push or pull over even surfaces.
Do not use on slopes.
Setting the drum down
1. Turn the bleed screw or the crank anti-clockwise and gently set the drum down.
2. The drum gripper unlocks automatically as soon as the drum is on the ground.
Dźwignik do beczek Servo z uchw. obr.
181088, 181090, 115293, 115295
181089, 181091, 147723, 147722
FW 12
wide
1540
0 - 750
with hydraulic pump with hydraulic pump
Strona 10 z 24
FW 16-F
FW 16-H
wide
wide
2130
2130
0 - 1400
0 - 1400
Wydanie 01/2010
with crank
Tabla de contenido
