Operation - MeisterCraft Professional MPMB 900 P Traducción De Las Instrucciones De Servicio Originales

MCP-5452900-Bediene-0909.qxd
and, at the same time, secures the
additional handle from vibration-related
sliding. Tighten the handle piece, by
turning to the right until the additional
handle is fixed to the machine.
Setting the depth stop (Figures 8a
and b)
• Insert a drill and lock into place.
• Loosen the wing screw (15) on the
additional handle (10) by turning to
the left.
• Insert the depth stop (3) into the
guide (c) in such a way (Figure 8a)
that the measuring scale on the front
insert (d) can be read (Figure 8b).
Push the depth stop to the length of
the inserted drill. Do this by pushing
the drill up against an even wall.
• At the front insert, read the relevant
value from the depth stop and deduct
the required drilling depth from this
value.
• Set the new value by sliding the
depth stop on the front insert. Fix the
depth stop in place by turning the
winged screw to the right.
8 – Operation
Revolution preset (Figure 9)
In order to protect the materials
you are working on, use the
revolution recommendations
made by the accessory manufacturer.
Revolution preset with adjustment
wheel (5):
• Turn the adjustment wheel in the "+"
direction as far as it will go = highest
62
revolutions.
30.09.2009 15:42 Uhr
• Turn the adjustment wheel in the "-"
direction as far as it will go = lowest
revolutions.
The revolutions can be controlled
steplessly using pressure on the on/off
switch (6) up to the preset revolutions
selected on the adjustment wheel (5).
When operating in continuous mode
with the on/off switch locked, the
machine operates at the preset
revolutions.
Setting the mode (Figure 10)
complete standstill!
knob (9) and turn the selection switch to
the right or the left and set the required
mode using the arrow symbol
the locking button to fix the selection
button in the selected position.
Meaning of the symbols
Seite 62
CAUTION! All modes may only
be set when the motor is at a
To set the appropriate
mode, press the locking
button on the selection
First gear
a. Drilling without hammer
function for wood with
conventional drill bits. For this
mode, a conventional chuck (11)
with adapter (supplied) is inserted
into the chuck (1).
b. Screwing screws into and out,
in conjunction with a
conventional chuck (11) and
suitable screwdriver bits (Figure
17)(not supplied).
Second gear
Drilling without hammer function,
ideally with metal, with conventional
high-speed steel metal drill bits.
. Release