Idiomas disponibles
Idiomas disponibles
Insert one of the two
5.
Wing Nut Bolts (#36099)
from the bottom up
through the slotted hole
in the Work Table and
into the hole nearest the
Angle Wedge on the
Table Fence. Tighten
loosely with one of the
two Wing Nuts (#36100)
Insert the remaining
Wing Nut Bolt up through
one of the three holes at
the opposite side of the
Work Table into the hole
at the opposite end of
the Table Fence. Tighten
securely with a Wing Nut.
Insert Rotary Tool into
6.
Tool Holder and secure
with the Tool Holder
Strap by tightening
the Restraining Bolt.
The assembled Work
7.
Center can be secured
to an appropriate work
surface by inserting
screws through the
holes provided in
each of the Feet.
Hole for Secured
Wing Nut Bolt
Wing Nut
Bolt
Angle Wedge
Secured
Wing Nut
Mounting Holes
Holder
Strap
-4-
Slotted
Hole
Adjusting
Wing Nut
Restraining
Bolt
