Idiomas disponibles
Idiomas disponibles
To assemble your Milescraft Work Center
The Tool Holder
1.
(#36030) is held
underneath the
Work Table (#32010)
by the two #10 x 15/16"
Phillips screws
(# 23671) which
extend downward
through the recessed
holes provided.
Insert screws
2.
downward from the
Work Table service into
the openings in the Tool
Holder (Fig. A) and
tighten until the Tool
Holder sits firmly
against the bottom of
the Work Table (Fig B.)
Place the end of the
3.
Swivel Arm between
the jaws of the Swivel
Arm Retainer on the
side of the Work Table.
Insert Hex Bolt
(#02005) and tighten
securely with washer
and Hex Nut (#00035)
A
Hex Nut
& Washer
Swivel
Arm
Jaws
-3-
Work Table
Recessed
holes for
screws
Tool Holder
B
