Setting Dip Switches And Scsi Id; Turning The Power On/Off; Turn On The Power - Sony StorStation LIB-D81 Guia De Inicio Rapido

Setting DIP Switches
and SCSI ID
Refer to the "Operating Instructions" (PDF) and
perform the appropriate DIP switch and SCSI ID
settings.
The default factory settings of the SCSI IDs are as
follows.
• AIT drive: 1
• Loader: 0
Turning the Power On/
Off

Turn On the Power

Turn on the AIT autoloader, then turn on the host
computer.
1
Press the power switch on the rear of the
autoloader, as illustrated.
The message display changes as follows and the
startup process begins. (Startup takes several
minutes.)
During startup, the following appears on the
message display.
Moves gradually up and down during the elevator check.
Indicates the startup phase, from 0 to 3.
When startup is complete, the message display
indicates the number of cartridges in the AIT
autoloader.
Starting up
Startup complete
When startup is complete, press the DOOR button
to open the front door and insert cartridges. For
details, refer to the "Operating Instructions" (PDF).
2
After pressing the power switch on the rear panel of
the autoloader, wait at least 10 seconds before
turning on the host computer.
Notes
• If you start the host computer before the autoloader,
the SCSI ID is not detected correctly. Therefore, you
must always start the autoloader before starting the
host computer.
• If the autoloader does not work as above, see
"Troubleshooting" in the "Appendix" in the
"Operating Instructions" (PDF).

Setting DIP Switches and SCSI ID

7