HURAKAN HKN-CL6 Manual De Instrucciones página 13

The unit should be installed on a steady table with sufficiently overall, dry and even
tabletop. In addition, humidity and ambient temperature in the work room should be about
75% and from +5°C to +35°C respectively.
3.2 Performance check
Checkout method:
●
Press "ON" start button and "OFF" stop button.
●
It is necessary to make sure that the cutter-mixer stops operating when the cover is
removed.
●
Check operability of the speed governor.
Chapter 4 Operation
4.1 Governor (see Figure 4)
Note: The design of the kitchen cutter-mixer provides the availability of speed
governor.
Figure 4. Controls
1. Set the number of revolutions by speed governor
2. Start the cutter-mixer by pressing ON button
3. Stop the cutter-mixer by pressing OFF button
4.2 Food product loading
Note: Food product loading can be performed only when the cutter-mixer is stopped.
The governor should be in the low speed position, "LOW".
Procedure:
1. Turn the press lever anticlockwise and remove the cover.
4. When loading food products into the bowl it is necessary to pay attention to the two
knives; if required, the product should be cut into small pieces before loading;
Attention: The product loaded should not fill the bowl more than by half.
5. For the purpose of safety, the operator should see after the position of their body
during operation of the cutter-mixer. It is necessary to keep the body upright. It is
not allowed to press the body on the mixer being in operation or try to place the body
in order to prevent a movement of the machine.
It is prohibited to approach the machine or directly touch the unit being in
operation.
6. Place the cover in the initial position, then turn the press lever until it clicks.
7. Press the start button.
EN
13