Eaton Powerware 5125 Guia De Instalacion página 25

3. Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 15 for more information on load segments).
Table 6. Plug Types Supported
IBM Plug Type
—
—
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high
power requirements of the heating elements.
NOTE To prevent an overload alarm, verify that the total equipment ratings do not exceed
the UPS capacity.
4. Bend and twist the cord retention clips around the equipment
power cords to secure the cord connections (see Figure 11).
5. If you installed an optional EBM(s), remove the breaker tie from all
battery circuit breakers.
Switch all battery circuit breakers to the ON (
6. Plug the detachable UPS power cord into the input connector on
the UPS rear panel.
®
EATON Powerware 5125 (9910-P33) UPS Installation Guide for IBM
Figure 11. Attaching the Cord Retention Clips
Description
IEC 320-C14
IEC 320-C20
®
Applications
INSTALLATION
Quantity Supported
9
1
|
) position.
S 11
164201634 Rev A