Würth WSB 400 Manual De Instrucciones página 6

3.2 Ignition Sequence
 SettheOn/Offignitionswitchtothe"ON"
position to release gas.
 Toturnoff,slidetheOn/Offignitionswitch
downward to the "OFF" position.
3.3 Clean­or­Replace­Orifice­Assembly
Remove tip and tip housing by loosening
knurled nut.
While holding the device in a vertical position,
unscrew assembly nozzle (A). You may have to
use pliers or other tool to start unscrewing.
Do not grasp and turn the ceramic head (D).
 Carefullyremovetheorificeassembly(B)by
lifting it out of the device (C).
 Notethattheshortersideoftheorificeassem-
blyfitsintothedevice.
 SoaktheorificeassemblyinNaphthaorother
similar solvent for 5 minutes.
 Replacetheclean(ornew)orificeassembly
(shorter side into the device).
Replace the assembly nozzle (hand tighten)
with pliers, grasping the shank of the assembly
nozzle.
Nozzle Assembly
6
Push the switch in the
direction of the tip to the
uppermost point to ignite,
then release the switch
back to the "ON" posi-
tion.
Do not touch the tip, tip
housing or knurled nut
while igniting.
Do not ignite the device if
"Tip Assembly" is not
screwed on.
Orifice Assembly
4. Cleaning
Use mild soap and a damp cloth to clean the
housings of the tool. Do not use household cleaners,
gasoline, turpentine or paint thinner. Never allow
any liquid to get inside of the device. Never immerse
any part of the device in liquid.