Uline H-8726 Manual Del Usuario página 9

COIL NAILERS
OPERATING ISSUE
Skipping fasteners;
intermittent feed
Fasteners jam in tool/canister
PAGE 9 OF 27
TROUBLESHOOTING CONTINUED
CAUSES
Feed piston dry
Feed piston O-rings cracked/worn
Check pawl binding
Canister bottom not set correctly
Broken weld wires in nail coil
Wrong size fasteners for tool
Broken welded wires in nail coil
Wrong slide plate adjustment for
wire collated nail coil
1-800-295-5510
uline.com
RECOMMENDATIONS
Add BOSTITCH Air Tool Lubricant in hole
in feed piston cover.
Replace O-rings/check bumper and
spring. Lubricate assembly.
Inspect pawl and spring on door.
Must work freely.
Set canister bottom for length of nails
being used.
Remove coil of nails and use another
coil.
Use only recommended fasteners/
check canister bottom adjustment.
Remove coil of nails and use another
coil.
Adjust switch pins for wire collated nail
coil.
0421 IH-8726