Cooling; Defrosting Of The Device (Fresh Food); Replacing The Interior Light Bulb - Blomberg SSM 1350 Manual De Instrucciones

Ocultar thumbs Ver también para SSM 1350:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
en

Cooling

Food storage
The fridge compartment is for the short-term
storage of fresh food and drinks.
Store milk products in the intended
compartment in the refrigerator.
Bottles can be stored in the bottle holder or
in the bottle shelf of the door.
Raw meat is best kept in a polyethylene bag
in the compartment at the very bottom of the
refrigerator.
Allow hot foods and beverages to cool to room
temperature prior to placing them in the
refrigerator.
Attention
Store concentrated alcohol only standing
upright and tightly closed.
Attention
Do not store explosive substances or
containers with flammable propellant gases
(canned cream, spray cans etc.) in the device.
There is a danger of explosion.
Defrosting of the device
The fridge compartment defrosts automatically.
The thawing water flows through the drain
channel into a collection container at the rear
of the device (Fig. 4).
During defrosting, water droplets form at the
back of the fridge due to the evaporator.
If not all of the drops run down, they may
freeze again after defrosting remove them
with a cloth soaked in warm water, but never
with a hard or sharp object.
Check the flow of the thawed water from time
to time.It may become plugged occasionally.
Clean it with a q-tip or similar (see the section
"Cleaning and care").
Replacing the interior light
bulb
(
Fig. 5)
Should the light fail to work switch off at the
socket outlet and pull out the mains plug.
Follow the below instructions to check if the
light bulb has worked itself loose.
If the light still fails to work obtain a replacement
E14 screw cap type 15 Watt (Max) bulb from
your local electrical store and then fit it as
follows:
1. Switch off at the socket outlet and pull out
the mains plug. You may find it useful to
remove shelves for easy access.
2. Remove the light diffuser cover as shown
in figure (a-b).
3. Replace the burnt-out light bulb.
4. Reassemble the light diffuser cover as
shown in figure (c).
"Push firmly to ensure cover is fitted properly."
5. Carefully dispose of the burnt-out light bulb
immediately.
"Replacement light bulb can easily be obtained
from a good local electrical or DIY store."
5
en
Tabla de contenido
loading

Tabla de contenido