SATA jet 4000 B Instrucciones De Servicio página 109

Operating instructions SATAjet 4000 B RP/HVLP
• Check if locking screw has been firmly tightened! Otherwise air mi-
crometer could shoot out from the spray gun uncontrolled!
9.6. Replace CCS (ColorCode-System)
The CCS for the individual marking of the spray gun can be exchanged
according to [10-6].
9.7. Replace spindle of round/flat spray control
steps: [11-1], [11-2], [11-3]
The spindle has to be replaced when air leaks from the spray control or
when the spray control does not work.
1. Removal of the old spindle [a]
• Remove screw [11-1] (Torx T20)
• Remove knob [11-2]
• Unscrew spindle [11-3] with wrench (size 14)
• Make sure that spindle pick-up is free of material and paint residues,
remove residues and clean with solvent, if necessary
2. Installation and positioning of the new spindle [a, b]
• Screw in spindle [11-3]
• Turn spindle nut [11-3] to position 6 o'clock using a wrench (size 6)
[11-4]
3. Positioning and assembly of control knob [c]
• Position of knob [11-2] has to be according to illustration (line in the
knob has to be in vertical position)
• Hand-tighten screw [11-1] (Torx T20) in the knob – hold knob in the
position while tightening
Warning!
EN
109