Mizuhosi hana 6875 Manual Del Propietário página 34

8.7 Attaching hana
®
The hana Knee Flexion System™ is designed to mount on the operative leg spar to support
and position the leg as needed during Total Knee Arthroplasty (TKA). It allows for full
flexion/extension of the leg and knee as well as internal/external rotation and planter/dorsal
flexion of the foot.
This device is intended to be used above the drapes in the sterile field.
Mizuho OSI's Knee Flexion System™ are supplied non-sterile. Cleaning and sterilizing of the
instrument(s) are required before each use according to your hospital's washing,
decontamination and sterilization procedures.
Figure 27: 6875 hana
Figure 27: 6875 hana
NOTE: Prior to draping, the fine traction must be adjusted fully towards the foot end of the
leg spar by rotating the traction handle clockwise until it stops.
Figure 28: 6875 hana
Prior to use, drape the operative side leg spar prior to attachment of the sterile Knee Flexion
System™ device. Maintaining sterile technique, position the distal end base onto the post
above the gross traction adjustment with the clamp around the fine traction upright and
tighten screw knob until secure (refer to figure 27).
MIZUHOSI 2009
®
Knee Flexion System™ For TKA 6875-230
Clamp knob
®
Knee Flexion System™ (6875-230) attachment detail, spar un-draped
®
Knee Flexion System™ (6875-230) attachment detail, spar un-draped
®
Hip and Knee Arthroplasty Table set up for right TKA spar draped
Fine traction
upright
Gross traction
adjustment
34 NW0508 Rev. D