PREPARE A FRONT LAMP ALIGNMENT SCREEN - DOMESTIC MARKET ONLY (CONT'D)
4. Rock the vehicle side-to-side three times to allow the suspension to stabilize.
5. Jounce the front suspension three times by pushing downward on the front bumper and releasing.
6. Measure the distance between the optical center of one of the lamps being aimed (head or fog) and the floor
(horizontal zero reference). Transfer this measurement to the alignment screen with a piece of tape placed
horizontally to the floor. This line will be used as the lamp horizontal reference.
7. Measure the distance between the vertical zero reference and the optical center of the nearest lamp being
aimed (head or fog). Transfer this measurement to the alignment screen with a piece of tape placed vertically
across the appropriate (head or fog) lamp horizontal reference. This is the centerline reference for the first lamp.
8. Measure the distance on center between the first and the second lamp being aimed. Transfer this
measurement to the alignment screen with a second piece of tape placed vertically across the appropriate
(head or fog) lamp horizontal reference. This is the centerline reference for the second lamp.
FOG LAMP ALIGNMENT
FOR THE FOG LAMP ALIGNMENT REFER TO THE IMAGE "FOG LAMP AIMING ASSESSMENT"
1. Turn the fog lamps ON.
2. Locate the adjustment screw at the back of the lamp. Use a
screwdriver to rotate the vertical adjustment screw on each
fog lamp to adjust the beam height as required.
Vertical Aiming Evaluation/Alignment -
fog lamp will project a pattern (top of fog light pattern) on the
alignment screen 4 in (100mm) below the fog lamp
centerline and straight ahead of the lamp.
Horizontal Aiming Evaluation/Alignment - No horizontal
(right/left) adjustment is required for the fog lamp.
FOG LAMP AIMING ASSESSMENT
NOTE: SEE DIAGRAM ON FOLLOWING PAGE
5-7-18
www.mopar.com
A properly aimed front
4"
(100mm)
7
K6862536
