VEHICLE PREPARATION FOR LAMP ALIGNMENT
NOTE: The Fog Lamps come pre-aimed from the supplier, but should be checked to ensure
proper aiming after installed in the vehicle.
1. Check for and correct any burnt out lights.
2. Repair or replace any ineffective, worn or damaged body or suspension components that could hinder proper
lamp alignment.
3. Verify proper tire inflation pressures.
4. Remove any accumulations of mud, snow or ice from the vehicle underbody and clean the front lamp lenses.
5. Verify that there is no load in the vehicle (cargo or passengers), except for the driver.
6. The fuel tank should be FULL. Add 2.94 kilograms (6.5 pounds) of weight over the fuel tank for each estimated
gallon of missing fuel.
7. Verify correct vehicle suspension height.
PREPARE A FOG LAMP ALIGNMENT SCREEN - DOMESTIC MARKET ONLY
FOR THE FOLLOWING STEPS (1 - 8) REFER TO THE IMAGE "FOG LAMP ALIGNMENT SETUP"
1. Tape a line on a level floor 7.62 meters (25 feet) away from and parallel to the flat wall that will be used as
the lamp alignment screen. The level floor will be used as the horizontal zero reference.
2. An adjacent wall or floor member that is perpendicular to the alignment screen can be used as the vertical
zero reference. If there is no adjacent wall or floor member that is perpendicular to the screen, tape a second
line on the floor perpendicular to both the alignment screen and the first line, and outboard of either side of
where the vehicle will be positioned. This will be used as the vertical zero reference.
3. Position the vehicle so that the side of the vehicle is parallel to the vertical zero reference, and so that the front
of the lamp lenses are in the vertical plane of the parallel line taped on the floor 7.62 meters (25 feet) away
from the screen.
7
6
FOG LAMP ALIGNMENT SETUP
5-7-18
www.mopar.com
8
2
1
8
7
6
3
6
K6862536
