Troubleshooting - Stiga SE 1814 Q Manual De Instrucciones

MAINTENANCE AND STORAGE
– close the tank cap and operate the machine until
all the cleanser runs out.
Remember to fill with oil, before using the machine
again.
8. BAR MAINTENANCE (Fig. 21)
To avoid asymmetrical wear on the bar, make sure
it is turned over periodically.
To keep the bar in perfect working order, proceed
as follows:
– Grease the bearings on the nose sprocket (if
pre sent) with the syringe.
– Clean the bar groove with the scraper.
– Clean the lubrication holes.
– With a flat file, remove burr from the edges and
level off the guides.
Replace the bar whenever:
– the groove is not as deep as the height of the
drive links (which must never touch the bottom);
– the inside of the guide is worn enough to make
the chain lean to one side.

9. TROUBLESHOOTING

IMPORTANT
mation in this Manual provides good machine no­
tions and the guide allows you to identify and face
the most common operating situations. For any
other difficulty or problem, please contact an Au­
thorised Service Centre.
• The machine does not start:
– make sure there is current in the socket;
– check that the power cable and extension lead
are intact.
• The chain does not turn:
– make sure that the front guard is positioned fa-
cing backwards.
Carefully reading the infor­
9. ELECTRIC CABLES
WARNING!
electric cables regularly and replace them if
they are worn or their insulation looks dam­
aged.
If the machine's power cable is damaged, it can
only be replaced with an original spare part by your
dealer or an authorised service centre.
10. EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
ma nual must be performed exclusively by your
dealer.
All and any operations performed in unauthori sed
centres or by unqualified persons will totally invali-
date the warranty.
11. STORAGE
The machine must be stored in a dry place away
from the elements and with the bar cover correctly
fitted.
• The oil does not flow:
– make sure there is oil in the tank and flush it if
necessary ( 8.7).
• Sparks form:
– contact your Dealer for an inspection of the mo-
tor and brushes.
EN
Check the condition of the
13