Uline TORK H-7544 Guia De Inicio Rapido página 2

1. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 5)
NOTE: To be ADA compliant, mount at a
maximum of 48" off the floor if forward reach
is required. See ADA Guidelines on page 4.
Figure 5
2. Using a 6 mm drill bit, drill into wall about 1⁄" at each
marked screw location on template. (See Figure 6)
Figure 6
3. Remove template from wall. Insert wall anchors
(if necessary) into four predrilled holes. Hold
dispenser up to wall so holes in wall and dispenser
match up. Insert screws into circular base of top two
holes but do not tighten completely. (See Figure 7)
Figure 7
PAGE 2 OF 12
MOUNTING
48"
4. Drop dispenser down so screws slide up into narrow
slots and tighten screws completely. (See Figure 8)
Figure 8
5. Ensure the dispenser is level by looking at the level
bar on the inside of the dispenser. If level, screw in
last two screws into bottom two holes. (See Figure 9)
Figure 9
0721 IH-7544