Dsp Settings - Kenwood KAC-X4R Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

DSP Settings

Perform DSP settings for channels A, B and LINE OUT.

Setting

1 Slide the DISP switch towards SET.

2 Slide the MODE switch to set the channel ("Ach", "Bch" or "LINE OUT").

3 Turn the control knob, display the item to set and push the control knob.

Repeat this step until the item to set is displayed.

To return to the previous menu, turn the control knob, display "RTN" and press the

control knob.

4 Turn the control knob, display the value to set and press the control knob. The

displayed value is set.

Items and setting values

Item

LN.SEL

LEVEL

FREQ (Hz)

(Mean frequency)

BAND1

(Parametric EQ-1)

GAIN

FREQ

BAND2

(Parametric EQ-2)

GAIN

FREQ

BAND3

(Parametric EQ-3)

GAIN

FREQ

BAND4

(Parametric EQ-4)

GAIN

FREQ

BAND5

(Parametric EQ-5)

GAIN

FREQ

LPF

(Low Pass Filter)

SLOPE

ISF

FREQ

(Infrasonic Filter)

FREQ

HPF

(High Pass Filter)

SLOPE

DELAY

PHASE

NOTE

• For LPF, HPF must be set to "TH".

• For ISF, HPF must be set to "TH".

• For HPF, LPF and ISF must be set to "TH".

• If LPF and ISF are set simultaneously, LPF frequency cannot be lower than ISF frequency.

NOTE

• If speakers are bridged, set "L" and "R" for "DELAY" to the same value. Effects will not be applied properly if they are set to different values.

• DSP settings will not be cleared even when the reset button is pressed.

English

Setting value

ST / CT/SW (Default setting value : ST)

-20 – 0 (Default setting value : 0)

25/40/60/80/100 (Default setting value : 25)

1.0/2.0/3.0/5.0 (Default setting value : 1.0)