Assembly; Operation - Blumfeldt Primal Heat 65 Manual Del Usuario

EN
16

ASSEMBLY

1. Put the main body up-side-down (Fig. A). Slide Deco.
Board (#6) onto Base Bracket (#5). Put the plug (#8) and
power supply cord (#7) through the holes on the center
of Base Cover (#4) and Base (#3). Then slide Base Cover
(#4) , Base (#3) and Washer (#2) onto Base Bracket (#5)
respectively.
2. Fix Washer (#2), Base (#3), Base Cover (#4) and Base
Bracket (#5) with Screw M6*20 (#1). Clip the power sup-
ply cord with Cord Clip (#7) and fix it onto Base (#3) with
Screw (#9).
3. Stand the unit correctly (Fig. C). Fix L Bracket (#13) onto
Alum. Fixtures (#10) with Screw M8*6 (#12) & M4*6
(#11) respectively. Then slide L Bracket (#13) into the
holes of Control Box (#14).
4. Fix L Bracket (#13) onto Control Box (#14) with Screw
M6*16 (#15).

OPERATION

1. Plug in the unit to a socket. Make sure the power supply is
same as rated.
2. Press LED Lighting Switch(#18) to switch on or off the LED
lighting.
3. Press Heater Switch(#16) to position "–" to switch on the
heater directly. Press Heater Switch(#16) to position "=",
IR sensors are activated. Sub Heating Element is on im-
mediately. IR Sensor indicator Light(#17) starts to flash.
When people or other objects are inside the sensing area
(within about 0.6M around the heater body), IR Sensor
Indicator Light(#17) lights up, and the main heating ele-
ment is switched on automatically, while the sub heat-
ing element is off automatically. When people or other
objects leave the sensing area, the main heating element
is switched off after 5 seconds, while the sub heating ele-
ment is switched on again automatically. IR Sensor LED
starts to flash again.