Cable Connections - Conceptronic Grab'n'GO CHD2UL Guía De Iniciación Rápida

ENGLISH
3. Hardware Installation CHD2UL
3.1 Assembling the CHD2UL (When no hard disk is installed yet)
If you bought the CHD2UL with a hard disk pre-installed, you can skip this step and
continue to step 3.2
a. Remove the 2 screws at the back of the CHD2UL.
b. Gently slide the hard disk tray out of the back of the housing.
c. Connect the 2,5" hard disk gently to the connector. Make sure the connector is
connected correctly to the hard disk.
d. Slide back the tray in the housing.
e. Fasten the 2 screws to secure the tray in the housing.

3.2 Cable connections

a. Connect the USB cable to the CHD2UL and to a free USB port on your computer.
The device will automatically power on.
Windows 2000 & XP Automatically will recognize the hard disk. No driver installation
is required to operate the CHD2UL.
Note: Some computers do not supply enough power on the USB port, which
results in a not-booting hard disk. In that situation, use the supplied
Power-to-USB cable to add extra power to the CHD2UL.
6