Garmin KT 15 Guia De Inicio Rapido página 5

Selecting and Installing the Contact
Points
For best results, select the correct contact
points based on your dog's coat.
1
Select the correct contact point length
for your dog's coat type:
• For dogs with thicker coats, use
the longer contact points.
• For dogs with shorter coats, use
the shorter contact points.
2
If necessary, use the included wrench
to remove the contact points.
3
Twist the contact points into the collar.
4
Tighten with the included wrench, but
do not overtighten.
When you put the collar on the dog, make
sure the contact points are tight against
the neck.
Fitting the Collar on Your Dog
CAUTION
To prevent irritation from the contact
points, remove the collar for at least eight
hours out of every 24-hour period.
This device is not intended for human use.
Do not attempt to use on any person.
4
Do not spray the device or collar with
harsh chemicals including but not limited
to flea or tick spray. Always ensure that
any flea or tick spray that is applied to the
dog is completely dry before placing the
collar on the dog. Small amounts of harsh
chemicals can damage the plastic
components and collar laminate.
In order to effectively train the dog, the
collar and device must fit the dog properly.
If the collar is too loose or positioned
incorrectly, stimulation may be
inconsistent. This can delay or prevent
successful training.
1
Position the device at the front of the
dog's neck, with the status LED facing
toward the dog's chin and the contact
points against the throat.
2
Tighten the strap so that it is very snug
around the dog's neck, and fasten the
buckle.
NOTE: The collar should fit tightly and
should not be able to rotate or slide on
the dog's neck. The dog must be able
to swallow food and water normally.
You should observe your dog's
behavior to verify that the collar is not
too tight.
Quick Start Manual