Troubleshooting - Kobalt SGY-AIR160TZ Manual Del Usuario

CARE AND MAINTENANCE
2. Let nozzle sit in solvent material(s) for 3-5 minutes allowing solvent material(s) to
break up any build up of dirt and or debris on spray nozzle.
3. Remove nozzle from solvent material (s) and closely inspect the spray gun nozzle
to ensure any dirt or debris build up has been cleared.
4. If debris or build up is still present, use a non-wire soft bristle brush and brush area
of nozzle that still contains dirt or debris and repeat steps 1-4.
NOTE: Depending on the paint and solvent material(s) used, steps 1-4 may need to
be repeated multiple times.
. Once the spray gun nozzle has been completely cleared of any dirt or debris and is
clean, wipe the nozzle clean with a clean cloth or rag.
. Once nozzle has been properly cleaned, reconnect the nozzle to the spray gun and
reconnect the spray gun to the air supply. Test the sprayer ensuring that it is
working properly.
Storing:
1. When not using the spray gun turn the fluid adjustment knob counterclockwise (to
open) which will reduce the spring tension on the needle fluid tip.
2. Spray gun must be well cleaned and lightly lubricated.
3. Store spray gun in a dry and safe place out of reach of children.

TROUBLESHOOTING

PROBLEM
Right or left heavy
spray pattern
Top or bottom heavy
spray pattern
Split spray pattern
POSSIBLE CAUSE
One side of nozzle
clogged.
a) Loosen air nozzle.
b) Material around outside
of air nozzle has dried.
a) Atomization air pressure
is set too high.
b) Trying to spray a thin
material in too wide of a
pattern.
is Soak nozzle
the clog, then blow air through until
clean. To clean orifices use a
broom straw or toothpick. Never
try to detach dried material with
sharp tool.
a) Trigger air nozzle.
b) Take off air
off fluid tip using a rag
moistened with thinner.
a) Reduce air pressure.
b) Increase material control by
turning fluid adjustment knob
to left, while reducing spray
width by turning spray pattern
adjustment knob to right.
12
SOLUTION
in solvent to loosen
nozzle and wipe