Canifugue Pro/Canifugue Mix Transmitter - Num'axes CANIFUGUE Pro Manual De Instrucciones

Ocultar thumbs Ver también para CANIFUGUE Pro:

Manual de instrucciones (16 páginas)

Tabla de contenido

Idiomas disponibles

corners with a large radius.

Separate the wire by at least 2 meters from a metallic gate or one meter from a metallic fence.

Do not install the antenna wire near an electrical cable, telephone cable, television cable or satellite dishes.

In order to prevent any interference, do not run the wire within 3 meters or parallel to electrical cables. If you must cross electrical wires, telephone

wires or television cables, do so at 90 degree angles.

If you need more than 100 m of antenna wire, you must connect the different lengths of wire using the supplied connectors (the wire does not need to

be stripped). You can purchase additional wire and connectors from your supplier at any time.

To ensure your dog does not receive any warning or stimulation in certain areas (e.g. between the transmitter in the garage and the edge of your

property) you have to twist the outward wire around the inward wire. The twists prevent radio waves from being emitted (ref. Diagram 1).

Once the loop is completed and you are back to the transmitter, strip the two ends of the wire to connect them to the supplied transmitter connector

(connect each wire with each connector screw). Then, insert this connector into the antenna socket located on the transmitter (ref. Diagram 2 – the

connector is slanted. If you can't insert it, turn it 1/2 turn).

The ﬂags are a temporary visual aid for your dog during the training process. They enable your dog to visualize the area where he can move freely and

the boundaries he must not cross.

We recommend installing the ﬂags at the inner edge of the warning zone at short intervals. Do not place the ﬂags at the antenna wire.

Once your dog is familiar with the boundaries, the ﬂags can be gradually removed.

Before starting the installation of your pet fencing system, it may be useful to draw a layout of the installation.

Once the installation is completed, note the location of the wire connectors on the layout you drew for future reference. In case of connection default,

you will ﬁnd them more easily.

AUTOMATIC SYSTEM

As soon as the animal wearing a collar enters the protected area, he

is warned by beep sounds.

If he continues to move forward, towards the antenna wire, the collar

emits stimulations.

The antenna wire is placed on the ground, buried or raised on an

existing fence.

For the system to function, the wire must form a continuous loop.

Both wires (inward and outward) must be spaced 2 meters apart.