First Time Setup - Powis Fastback 25 Manual Del Usuario

!
:
Heaters are hot. Do not touch
C A U T I O N
heater surfaces during binding. Do not touch
heaters immediately after removing book.
:
Do not place fingers and other
C A U T I O N
foreign objects into binding cavity during binding
process. Binding cavity closes during binding
process and may pinch.
III FI RST TIM E SETU P
A. What's Included Inside the Box
• The Fastback® Model 25 Photobook binder
• Accessory Box, which contains:
- Smaller Accessory Kit (includes Heat Protective Glove,
Wire Tweezers, and Cleaner
- Power Cord
- Book Fence
- Key (European model) • Cooling Rack
If any items are damaged or missing, contact Powis Parker dealer
immediately .
B. Setting Up
1 . With the help of someone else, remove the binder from the box .
2 . Position the machine on the desk, table, or counter where it will
reside . We recommend placing your binder near the Fastback Splitter .
3 . Remove cardboard shipping pieces from the top and inside of the
binder as described on the unpacking sheet attached to the binder .
4 . Connect the heater thermistor/thermostat connectors inside the
binder as described on the unpacking sheet attached to the binder .
5 . Remove the plastic book fence from the cardboard liner in the box .
6 . Attach the fence to the Fastback® binder by aligning the two slots
in the plastic fence with the metal tabs on the book clamp . Hold
the fence on each side, and insert the tabs firmly into the slots .
5 . Unpack the cooling rack and place it on top of the rear of your
Fastback® binder . The long, bent metal tab under the front of the
rack should be inserted in the slot above the four printed icons .
C. Plugging In
1 . The power switch is located at the lower left on the front of the
machine . Before plugging in the Fastback® binder, make sure the
power switch is off by depressing the "O" side of the power switch .
2 . Plug the power cord into the outlet on the back of the machine .
Then connect it to a standard, grounded electrical outlet .
D. Ready To Go
Turn the power switch on by depressing the "1" side of the power
switch . Display will read "WARMING UP ." In approximately 5–10
minutes the display will read "READY TO BIND ." Now the machine
is ready to use .
The Model 25 Binder consumes relatively little power when it is
HIN T :
not binding . However, if the machine will not be used for several hours,
save power by turning it off .
FASTBACK PHOTOBOOK BINDER MODEL 25 USER'S MANUAL, 203794