2
SAFETY WARNING
2.1 WARNING FOR THE INSTALLER
Observe the prescriptions contained in this manual.
•
The stove removal and installation instructions are
reserved to specialist technicians only.
•
It is always recommended that users contact our
technical assistance service to request qualified
technicians. In the case other technicians are
involved, it is recommended to verify their actual
abilities.
•
Responsibility for the works carried out in the
location of the machine is, and remains, attributable
to the user; the latter is also required to perform
checks on the proposed installation solutions.
•
The user must comply with all local, national and
European safety regulations.
•
The appliance must be installed on floors with an
adequate load bearing capacity.
Check that the flue and air intake predispositions
conform to the type of installation.
•
Do not carry out flying electrical connections with
provisional or non-insulated cables.
•
Check that the earthing of the electrical system is
efficient.
•
It is prohibited to install the stove in bedrooms,
bathrooms and shower rooms, in rooms where
combustible materials are stored and in studio
apartments.
Installation is allowed in studio apartments only
with outside air intakes and if properly installed in
accordance with regulations;
•
Under no circumstances can the stove be installed
in rooms where it is exposed to contact with water
or splashes of water, as this may cause the risk of
burns and short circuits.
•
In accordance with fire safety laws, the clearances
from flammable or heat-sensitive objects must be
respected (sofas, furniture, wood cladding, etc.).
•
In the case of highly flammable objects (curtains,
carpet, etc.), all these clearances must be increased
by 1 metre.
2.1.1 WARNINGS FOR THE INSTALLER
The person in charge of the installation, before
starting assembling or disassembling of the stove,
must comply with the safety precautions required
by law and in particular:
A) do not operate in adverse conditions;
B) must operate in perfect psychophysical
conditions and must check that the personal
protective equipment, are intact and functioning
perfectly;
C) must wear safety gloves;
D) must wear safety shoes;
E) must use electrical insulated tools;
F) must ensure that the area affected by the
phases of assembly and disassembly is free
from obstacles.
2.2 WARNING FOR THE MAINTENANCE
TECHNICIAN
Observe the prescriptions contained in this manual.
•
Always use individual safety devices and other
means of protection.
•
If the floor is made of combustible material, it
is recommended to use protection in a non-
combustible material (steel, glass) that also protects
the front part in the event of any fuel spills during
cleaning operations.
•
Before starting any maintenance operation, make
sure that the stove has cooled down if it has been
used.
•
If even one of the safety devices is found to be out-
of-adjustment or not functioning, the stove should
be considered as not functioning.
•
Non-specialised users must be prevented from
accessing any parts that may expose them to
dangers. This person must therefore not be allowed
to intervene on internal parts at risk (electrical
or mechanical), even if the disconnection of the
electrical supply is required
•
Disconnect the power supply before working on
electrical and electronic parts and connectors.
2.3 WARNING FOR THE USER
Do not touch and do not approach the door glass
as it could cause burns;
•
Do not look at the flame for a long time;
•
Do not touch the flue gas exhaust pipe;
•
Do not dispose of hot ash (ensure it is completely
extinguished and cooled before vacuuming or
removing it);
•
Do not open the glass door;
•
do not open the ash drawer (where provided);
•
Do not touch and do not approach the glass of the
door, it could cause burns;
•
Do not look at the flame for a long time;
•
Do not touch the flue gas exhaust pipe;
•
do not perform any type of cleaning;
•
Do not dispose of hot ash (ensure it is completely
extinguished and cooled before vacuuming or
removing it);
•
Do not open the glass door;
•
do not open the ash drawer (where provided);
•
Do not use the appliance as a waste incinerator.
•
It is prohibited to operate the product with the door
open or the glass broken.
•
It is prohibited to make unauthorised changes to
the appliance.
•
Do not use flammable liquids during ignition
(alcohol, benzene, oil, etc.).
•
After a failed ignition attempt, the accumulated
pellets must be emptied from the burn pot before
igniting the stove again.
•
The pellet tank must always be closed with the lid
on.
02/2021 - EN
7