Die Installation / Maintenance - Rhin-O-Tuff HD7700/H Manual De Usuario

Providing power to the machine:
Power cord shall be certified for the country
u
where the machine will be installed. Plug one
end of the power cord into the power cord
receptacle on the back of the machine. The
other end goes into the wall outlet.
Die Installation:
HD7700/H, HD7650, HD7100, HD7000, HD7000
u
Plus & HD7500/H: Diagram 1.
machine is turned off before installing the
die .
Make sure there is no paper dust or paper chips
u
in the machine die slot before installing the die.
Install the die by sliding it into the opening located on the right hand
u
side of the machine. Make sure the punch pin retainer slides into the
slot on the back side of the opening.
Rotate both quick-change die handles to the lock position. The
u
machine will not operate unless the handles are in the locked position.
Diagram 1. (Image of HD7000)
Make sure the
6
! DANGER
Hazardous voltage.
Use only approved
power cord
assemblies.
!
WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.