Rhin-O-Tuff HD7700/H Manual De Usuario página 12

Punching Paper:
Select an appropriate number of sheets to be punched and slide the
u
sheets down vertically (Horizontally for the HD7700H and HD7500H)
into the opening of the die assembly. When the paper is fully inserted,
slide it to the left so it comes in contact with the paper stop. Make sure
all the edges of the sheets are flush by tapping the top and the right
hand sides of the sheets before activating the punch.
If a paper activated switch is being used, tap the sheets flush
before sliding the paper to the paper stop.
Removing Paper Waste:
The paper waste drawer is located conveniently on the front of the
u
punch. The paper waste drawer is removed by lifting up on the front
and pulling out away from the machine. This drawer should be
checked frequently while punching and emptied as necessary.
Paper Jam:
The
HD7700/H, HD7650, HD7100, HD7000, HD7000 Plus, HD6500, HD6700
u
and HD7500/H
cycle, this circuit board also has the ability to automatically reverse the
punch pins to their starting position in the event of a paper jam. This
condition could happen if too much material has been attempted to be
punched at one time. If this condition occurs, the machine will attempt
to reset itself back to its home position.
itself back to its home position, the punch can be reversed manually.
Turn the machine power switch off and
u
remove some or all of the material in the
punch.
It is easier to remove one or two sheets at a time from the
backside of the material in the punch, top side for the HD7700H
and HD7500H.
punches use a circuit board for controlling the punch
If the punch does not reset
10
! WARNING
Crush hazard.
Keep hands away
from moving parts.
Lockout and disconnect
power before servicing.