LUND Elite Serie Instrucciones De Instalación página 4

Installation Steps
Use a razor blade to cut and install rubber trim on the
new fender flare edge, that will mount against fender.
16
Align new fender flare with holes in fender.
18
With fender flare in final position, tighten all bolts and nuts using hand
tools only. Reattach splash guard that was loosened in Step 15.
DO NOT OVER TIGHTEN.
20
NOTE: Actual application may vary slightly from illustrations.
Repeat Steps 1 thru 20 for opposite side.
Place a bolt through a hole in the new fender flare, and
place a black spacer on the bolt on the opposite side of
the fender flare to retain it in place. Repeat for remaining
bolt
through
this side
17
Reach behind the flare and place a washer and nut
on each bolt to secure fender flare to fender. DO NOT
19
fender flare
bolt
Page 4 of 5
holes.
FULLY TIGHTEN AT THIS TIME.
spacer
fender
Cross Section
spacer on
this side
washer
nut