Instrumax SNIPER 50 PLUS Manual Del Usuario página 7

Indirect measurement
Pythagorean measurement is used in the condition that the
objective needing to be measured is covered or has no effec-
tive relecting surface and can't be measured directly.
Make sure you adhere to the prescribed sequence of mea-
surement:
All target points must be in a horizontal or vertical plane.
The best results are achieved when the instrument is rotated
about a ixed point (e.g. with the positioning bracket fully fold-
ed out and the instrument placed on a wall) or the instrument
is mounted on a tripod.
It is possible to use minimum / maximum function. The mini-
mum value must be used for measurements at right angles to
the target; the maximum distance for all other measurements.
Indirect measurement – determing a distance using 2
auxilary measurements.
E.g. When height and distance can't be measured directly.
Press button (5) 3 one time. The symbol
The distance to be measured is blinking in the symbol tri-
angle.
Press button (4) to take distance measuring
is displayed in the irst line.
Press button (4) to take distance measuring.
After pressing button (4) the result is displayed in the irst
line. The result of the function
line.
Indirect measurement – determing a distance using 3
measurements.
Press button (5) 2 times. The symbol
distance to be measured is blinking in the symbol triangle.
Press button (4) to take distance measuring
triangle). The result of the function is displayed in the sec-
ond line.
Press button (4) to take distance measuring
the triangle) . The result of the measurement is displayed
in the irst line.
is displayed.
. The result
is displayed in the second
is displayed. The
(side of the
(height of
7