Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IV. Initial setup
1.
Start by installing the two AAA batteries supplied inside the remote control.
2.
Plug the AC cable into a wall outlet.
3.
Connect the 3.5mm plug into the auxiliary and/or the DVD port to the corresponding input of the speaker's
back panel.
4.
Proceed to connect the other side of the 3.5mm plug into the media device of choice, such as a laptop,
television set, MP3/4 player, smartphone or tablet.
5.
Connect the antenna to the RCA jack labeled 'Antenna' on the main speaker's back panel.
6.
Turn on the speaker by pressing the red power button on the remote control.
7.
Select the input mode of choice using the source button on the main unit or by pressing the corresponding
button on the remote control.
8.
Use the controls on the front of the unit or the remote control to start enjoying the speaker system.
9.
Press the Power button on the remote control to turn OFF the unit.
V. Advanced operation
Pairing the speaker with your Bluetooth
device
®
Note: Before installing this product, please make sure your device is compatible with Bluetooth
speaker will connect to only one device at a time. In order to connect to the unit verify that there is
no other device already paired with it.
1.
Press the Power button on the remote control to turn ON the unit.
2.
Enable the Bluetooth
function on the device of choice and set it to discover the wireless speaker.
®
3.
Next, press the SOURCE button on the speaker or on the remote control to enable the Bluetooth
The bt icon appears on the screen to indicate that the system has entered into the pairing mode.
4.
Once the speaker appears listed under the newly found Bluetooth
seconds for pairing.
5.
If pairing is successful, it will indicate that the speaker system is connected. If after 60 seconds the pairing
process fails, please repeat steps 2 through 5 described above.
6.
You can now start streaming audio through the speaker wirelessly from your favorite Bluetooth
devices.
7.
The speaker will re-pair automatically to the memorized device when the BT mode is selected on the unit
after being turn off and on again.
. The
®
feature.
®
devices (KFS-500), select it and wait a few
®
- enabled
®
Technical specifications
MPN
Device
Type
Floor standing speaker
Maximum power output (PMPO)
3000W
Reference RMS power
320W
DC input
25V
Buttons
ST-BY/PLAY-PAUSE, SOURCE, TUN+/NEXT
TRACK, TUN-/
PREVIOUS TRACK, VOL+, VOL-
AC input
110V-240V (autosensing)
Driver
Driver unit
Two 6.5in subwoofers
Two 3in tweeters
Reference RMS power
320W
Frequency
Tweeter: 120Hz-20kHz
Subwoofer: 20Hz-170kHz
Impedance
Tweeter: 4
Subwoofer: 4
Sensitivity
870mV
Signal to noise ratio
≥60dB
Total harmonic distortion (THD)
≤ 1%
Microphone
Directivity
Cardioid
Frequency
75Hz-14kHz
Impedance
530 ±30% (at 1kHz)
Sensitivity
-71dB±3dB
Connectivity
Connection type
Bluetooth
two ¼in ports
Memory card slot
USB/SD
Wireless RF frequency
UHF: 261.8 MHz
Wireless range
82ft
Specifications
Product dimensions (DxWxH)
11x7.9x29.3in
Product weight
17.6lb
Cable length
5ft
Warranty
One year
KFS-500
compatible, two 3.5mm ports, FM,
®
™
Tabla de contenido
