105.Place in position driver side windshield garnish molding
assembly. See Figure 35.
FIGURE 35
106.Connect the electrical connector (3).
107.Tabs must be installed prior to retainers.
108.Tabs to be fully seated in instrument panel retainer and
valance panel. The outside edge of the driver's side wind-
shield garnish molding must be seated behind the roof rail
weatherstrip.
109.Install windshield side garnish molding screw (2).
Tighten
Tighten the screws to 2 N•m (18 lb in)
110.Install windshield side garnish molding cover (1).
111.Place in position passenger side windshield garnish molding
assembly.
Full Size Truck and SUV Navigation Radio Kit
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
112.Connect the electrical connector.
113.Tabs must be installed prior to retainers.
114.Tabs to be fully seated in instrument panel retainer and
valance panel. The outside edge of the passenger's side
windshield garnish molding must be seated behind the roof
rail weatherstrip.
115.Install front assist handle assembly (3) (passenger side
only). See Figure 36.
FIGURE 36
116.Install passenger windshield assist handle cover screws (2).
(Quantity 2).
Tighten
Tighten the screws to 6 N•m (53 lb in)
117.Install passenger windshield assist handle cover (1). (Quan-
tity 2).
118.Connect the negative battery cable to the battery.
119.Turn the ignition switch to the ON position. The AIR BAG
indicator will flash then turn OFF.
120.Program Navigation Radio with the latest &U3U or &UVB
calibrations in the Service Programming System - refer to
Service Procedure 1265170.
121.Program recorded preset stations for all radio bands.
PART NO.
REV25MR08
INSTALLATION INSTRUCTIONS
DR
TITLE
Full Size Truck and SUV Navigation Radio Kit
PART NO.
19153971
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19153971
SHEET
10
SHEET
10
30
OF
30
OF