TEFAL EXPRESS ANTI-CALC Manual Del Usuario página 22

• Press the illuminated on/off switch and unplug the generator.
• Place the iron on the housing plate on the steam generator.
• Raise the retaining hoop over the iron until it locks into place (audible click)
• Your iron is then safely retained on its base. Warning: do not touch the soleplate while still hot.
• Slot the extension cord outlet in the notch (depending on model). Take the end of the cord support and
press to return the flexible part into the base.
• Store the steam cord in its slide storage place
end of this loop in the slide storage place then push gently until you see the end on the other side of the
slide storage place
• Leave the steam generator to cool for at least one hour before putting it away if it is to be stored in a
cupboard or confined space.
• You can store the steam generator in complete safety.
Problems with your steam generator?
The steam generator does not switch on
or the iron indicator and ON/OFF
indicator do not switch on.
Water runs out of the holes in the
soleplate.
Water streaks appear on the linen.
To extend the life of your steam generator and avoid scale on your ironing, your steam generator
is equipped with a built-in scale collector. This valve, located in the tank,
automatically removes the scale that forms inside.
• An orange "anti-scale" light located on the control panel starts blinking to tell you that the anti-
scale valve needs rinsing
• Once the steam generator has cooled down completely, remove the scale collector cover
• Unscrew the anti-scale valve and remove it from the housing; it contains the scale that has built
up in the tank
• To clean the valve properly, just rinse it under running water to remove the scale it contains
.
• Put the valve back into its housing and screw it in completely to keep it watertight
• Refit the scale collector cover
.
The appliance is not switched on.
Water has condensed in the pipes because
you are using steam for the first time or you
have not used it for some time.
The soleplate is not hot enough.
Your thermostat is faulty: the iron is not
hot enough.
Your ironing board cover is soaked with
water as it is not suited to the power of a
steam generator.
and .
.
. Take it, fold it in two so as to make a loop. Put the
.
Check that your appliance is correctly
plugged in and press the illuminated
on/off switch.
Press on the steam control button away
from your ironing board until the iron
produces steam.
Decrease the steam output while ironing
at low temperature (steam output control
dial on the control panel). Wait for the
thermostat light to go out before
activating the steam control button.
Contact an Approved Service Centre.
Check that your ironing board is suitable
(See page 20).
.
.