TEFAL EXPRESS ANTI-CALC Manual Del Usuario página 20

To transport your steam generator using the handle of the iron :
- place the iron in position on the housing plate on the steam generator and fold the ring over the
iron until it locks into position (you will hear a "click")
- Hold the iron by the handle to transport your steam generator
Preparation
• Your iron has been designed to operate using untreated tap water.
• Heat concentrates the elements contained in water during evaporation. The types of water
listed below contain organic waste or mineral elements that can cause spitting, brown staining
or premature wear of the appliance: water from clothes dryers, scented or softened water,
water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or
rain water should not be used in your iron. Also do not use boiled, filtered or bottled water.
• Your iron is equipped with an extension cord system to prevent the cord from dragging over
the laundry and creasing it again when ironing.
• Take the steam cord out of its housing and unwind it completely.
• Remove the tie to release the cord outlet.
• Press the Eject button
• When the cord outlet tips, the Easycord system extends automatically without you having to
press the Eject button.
• Green light flashes: the boiler heats up.
• Green light on: the steam is ready
• Red light "water tank" on: the water tank is empty
• The orange "anti-calc" indicator flashes
Use
• Place the iron's temperature control slide according to the type of fabric to be ironed (see table below).
• The thermostat light comes on. Be careful ! The steam generator is ready when the thermostat
light goes out and when the green "steam ready" light stays on.
• Adjust the steam output control dial (located on the control panel).
• While ironing, the light on top of the iron and the steam ready light turn on and off, as the
temperature adjusts without interrupting ironing.
• To obtain steam, press on the steam control button under the iron handle and keep it pressed -
fig.8. The steam will stop when you release the button.
• When starting, and regularly while it is being used, your steam generator's electric pump injects
water into the boiler. It makes a noise but this is quite normal. You may also hear a clicking noise
which is the steam valve opening. Again this is normal.
• Always spray starch onto the reverse side of the fabric to be ironed.
• Place the steam generator on a stable, horizontal and heat-resistant surface.
• Ensure that your steam generator is unplugged and that the soleplate and the iron rest have
cooled down.
• Open the water tank filler cover
• Pour in untreated tap water up to the max mark
• Close the water tank filler cover.
and the Easycord system extends automatically.
• Completely unwind the power cord and the steam cord from its storage space.
• Lower the retaining hoop (depending on model) to unlock the safety catch
• Plug your steam generator into a mains socket with an earth pin".
• Press on the on / off switch. The green light (located on the control panel) flashes and the
boiler heats up
When the green "steam ready" light stops flashing (after 2 minutes approximately), the
appliance is ready.
.
.
: you need to rinse the scale collector.
.
.
.
.
.
.
.