Assembling And Adjustments - Flymo Speedi-Mo 360VC Traducción De Las Instrucciones De Empleo Originales

See Picture 0.
1 Start/stop lever
2 Lock off button
3 Cable clip
4
Wing knob
5 Lower handle
6 Safety guard
For further advice or repairs, contact your local
dealer.
Assembling the handle
1 Insert the lower handles into the holes provided in
the deck. Secure with the wing knob (Picture A1).
2 Attach the upper handle to the lower handles with
the wing knob (Picture A2).
The upper handle is height adjustable. The handles can
be fi xed in position I or II as desired (Picture A2).
Note: Ensure that the cable clips are used to fi x the
cable to the handle.
Attach the cable to the cable hook ensuring that suffi -
cient cable slack is available.
Ensure the cables are not trapped when folding and
unfolding the top handles. Do not drop the handles.
Assembling the grassbox
1 Push the grassbox handle into the slots in the
grassbox upper until it clicks securely into positon
(Picture B1).
2 Connect the two parts of the grassbox together, then
install the tongue (Picture B2).
3 Starting at the rear of the grassbox, install the grass-
box cover into the grassbox with the clips.
Ensure all clips are correctly located (Picture B3).
Starting and stopping
To start your lawnmower
1 Squeeze the start/stop lever (Picture D1) towards the
handle.
2 Press and hold the safety button (Picture D2).
3 Release the safety button.
IMPORTANT! Make sure the blade
!
stops rotating before switching on
again. Do not rapidly switch on and off.
To stop your lawnmower
1 Release the pressure on the start/stop lever.
Grassbox full window (360VC)
As the grassbox fi lls up, grass will be visible through the
WHAT IS WHAT?

ASSEMBLING AND ADJUSTMENTS

OPERATING
7 Upper handle
8 Grassbox upper
9 Motor cover
10 Wheel
11 Deck
12 Grassbox lower
13 Height adjust lever
4 Attach the complete grassbox to the lawnmower
(Picture B4).
a. Lift the safety guard.
b. Make sure the discharge chute is clean and free
from debris.
c. Install the fully assembled grassbox onto the
location points at the rear of the deck as illustrated.
d. Place the safety fl ap on top of the grassbox.
Note: If you do not want to collect the grass, the lawn-
mower can be used without the grassbox. The safety
guard must be in the down position.
Adjusting the cutting height
WARNING! Release the lever and wait
!
until the motor stops before adjusting
the height. The blades continue to
rotate for a few seconds after the ma-
chine is switched off. A rotating blade
can cause injury.
Adjust the cutting height by moving the height adjust-
ment handle (Picture C).
Five cutting heights are availabble on this product.
Note: A medium height of cut is recommended for most
lawns.
window.
When the window/grassbox is full it is time to empty the
grassbox.
How to mow
1 Start mowing the edge of the lawn nearest to the
power point so the cable is laid out on the lawn you
have already cut (Picture E).
2 Mow twice a week during the growing season. Your
lawn will suffer if more than a third of its length is cut
at one time.
DO NOT OVERLOAD YOUR LAWNMOW-
ER
Mowing long thick grass may cause the motor speed to
drop. You will hear a change in the motor sound. If the
motor speed drops you may overload your lawnmower
which may cause damage. When mowing in long thick
grass a fi rst cut with the cutting height set higher will
help reduce the load. See "Adjusting the cutting height."
English – 7