Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
INTRODUCTION
Please read this manual before carrying out any operation. It is compulsory to read this instruction
manual before starting any kind of action. The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this manual are closely adhered to.
We guarantee that this product complies with the technical specifications described in this manual.
The manufacturer shall not be held responsible for any improper uses other than those described
herein. Use protective work gloves, protective footwear, hard hat and safety goggles.
Misuse:
- This product should only be used as described in this documentation; any other use
is considered improper.
- The manufacturer accepts no responsibility for any damage caused by the incorrect or
unreasonable use of the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
PROCEDURE
The tool set for the disassembly and assembly of the DSG (Direct-Shift Gearbox) was designed to
remove the clutch casing, including the discs, of 6-speed (code 08D) and 7-speed (code 0AM) VAG
gearboxes, dual clutches (K1 and K2) and multiple shafts used in cars of the VAG Group since 2003.
K1 = Clutch no.1
K2 = Clutch no.2
DUAL CLUTCH DISASSEMBLY
Warning: when removing the gearbox, closely adhere to the instructions provided by
the car maker/manufacturer.
- Place the gearbox on a suitable workbench and position it so that the clutch casing bell faces upwards.
- Remove the upper safety ring of the clutch disc hub (K1) using a screwdriver or a hook.
- Remove the safety ring and the clutch disc hub (K1).
- Use pliers E to remove the safety ring of the main outer shaft.
If the safety ring is locked, press on the center of the clutch using components A and D, assembled
directly on the clutch casing bell.
Make sure the cross member is properly secured and that the thrust bushing works perpendicular to
the clutch casing bell.
Warning: lubricate the drive screw and press it only as much as necessary to avoid
damage to the main outer shaft support and the gearbox.
- Fit extractor B into the clutch unit and lock it into place by turning it clockwise.
- Act on the extractor's screw and remove the clutch unit of the main outer shaft.
EN
I
13
