D-Link DCS-4633EV Manual Del Usuario página 11

Using the DCS-37-2 Mount (optional)
Place the DCS-37-2 mounting sticker in the desired
location, then use a 6 mm drill bit to drill the required holes
25 mm deep and insert the wall anchors into the holes. If
you plan to pass cables through the ceiling, you will also
need to drill a hole for the cable channel.
Note: The camera in the corresponding graphics may be
different from your product, but the procedure is the same.
Use the provided screws to mount the DCS-37-2 to the
wall using the inner mounting holes.
Guide the camera connectors through the back or side
cable channel on the DCS-37-2. Use the provided screws
to mount the camera to the DCS-37-2 using the set of
mounting holes marked B.
Remove the cover from the camera.
Use the provided screws to mount the camera to the
DCS-37-2, then adjust the angle and rotation of the
camera as desired using the tilt lock screw.
Attach the camera cover.
If you are passing the camera cables through the ceiling,
place the rubber stopper into the side cable channel to
seal it.
9
D-Link DCS-4633EV Quick Installation Guide